Instructs a relay to turn on or off automatically based on sensor data input.
When setting up a rule:
- Name:
- Allows users to name (or change the name of) the relay.
- Turn:
- Select the state the relay will change to if the parameter is met.
- Note: This is the state of the relay itself, and not that of the logic the relay outputs.
- At:
- The Sensor Board that the reading is being provided from.
- When:
- The sensor that the parameter will be read from.
- Is:
- The logic used to set the parameter.
- Value:
- The sensor value, as determined by the logic that must be met in order to trigger the relay.
- Must be a whole number.
See this document for instructions on setting up Rules.